Recent content by Brunnka_CTX

  1. Brunnka_CTX

    Brunnka_CTX

    My CTX
  2. CTX700-0323.jpg

    CTX700-0323.jpg

  3. CTX700-0325.jpg

    CTX700-0325.jpg

  4. CTX700-0326.jpg

    CTX700-0326.jpg

  5. CTX700-0327.jpg

    CTX700-0327.jpg

  6. B

    750-cc CTX?

    I might at some point but not right away. I was planning to test out the NC 750 whenever it finally shows up at my dealer just check out the new motor and updated transmission. However, I really like the way I have my bike setup. The nice thing about having a CTX750 available would be that all...
  7. B

    First bike picture 2018

    I'm about 6' 2" and have a 32" inseam. When I first got my bike I put a 20" Madstad windshield on it which turned out to be too short. However, I waited before replacing it since I knew I was going to be putting a Corbin seat on it and wasn't sure the 22" was going to be enough or if I was...
  8. B

    New guy from St Louis MO

    Welcome to the forum. I live about 33 miles northeast to St. Louis so maybe we'll past each other when I'm over across the river. There are a lot of great roads to ride in Missouri.
  9. B

    Who rode today?

    I got to ride a little on Sunday, but it’s freezing rain last night, this morning and this evening. So, it will be a little while before next time.
  10. B

    corbin seat and back rest 700D

    I have the Corbin standard of high seat. I've got about 10000 miles on it and I like it a lot. I just added the back rest and was able to take it out for a ride with it today. I believe it is going to work out just fine. Best of luck with your ride.
  11. B

    Map

    Go right to the top of the page and click on "member map'. It pops right up.
  12. B

    MadStad farkles for the N model

    I installed the Honda sub harness and connected to that. The other leads from the Garmin wiring harness such as the USB, microphone, and audio connections I just ran into the compartment under the seat in case I want to use them later. I connect my headset to the Garmin using Bluetooth.
  13. B

    MadStad farkles for the N model

    You're right about the crossbar being a great place to mount a GPS.
  14. B

    Let's see your large saddlebags

    Your right, you would have to go with the Hepco and Becker rear luggage rack. That's the rack you see in the pictures I posted. It's made to allow the side carrier to be take on and off without removing the rear rack. The H&B back rack comes with a set of inner supports, but if you using it...
  15. B

    Let's see your large saddlebags

    Dave, The Hepco and Becker journey 42L boxes interior measurements are 19.75” across the top and 18.5” across the bottom. The side of the box that mounts to the bike is 6.75” deep and the lid is 4.5” deep for a total of 11.25 inches. The box Height is 12.5” at the side which is the lowest...
Top