running light,s

ron gerhart

New member
mounted the light,s and wired them up the light,s are from amazon Lylla cree day light 10 watt 25.00 dollar,s came with a switch i did mount them in the flareing up high very easy to do used the light mount,s that came with the light,s while i had the wind shield off i also change the head light bulb 20180213_123329.jpg
 

casper

New member
Looks good. Can you show a picture where and how they're mounted. I haven't mounted mine yet, it's too cold yet. I was planning on mounting them on the fender bolt.
 

Shanghai Dan

New member
Might need to consider moving them lower if they wash out your blinkers. That's law, and one of the reasons that a fog light that is close to a turn signal turns off if the turn signal is on.
 

burdicda

Member
http://www.greenknights36.com/gallery3/index.php/My-CTX-So-Far?page=2

From Northern Tool
$25 a pair on sale often
They are "working" lights meaning not beamed but a wall of light...so I aim them down
First time mounted them to the metal clips that hold the reflectors but one broke from vibration
If you click and click on the pictures they zoom/enlarge
you will see I bought some steel bar from home depot and cut off about 2-3 inch length of flat bar
and drilled out replacing the original reflector "pot metal" clips....no more vibration...
The bolts are stainless and the sliders are aluminum...
A little bit of a job...but I just "had to have" those lights...LOL
They did a thousand mile ride from DC to Florida down the Blue Ridge Parkway as they are in the picture...

ciao..

Danny

http://www.greenknights36.com/gallery3/index.php/My-CTX-So-Far?page=4

The 2nd link shows the flat clips snug up against mount
The first link shows them standing out on the cheap pot metal clips that come with the bike...
 
Last edited:
Top